|
Request water-Stop water
replace a 2 wire control cable from the pivot to the well
pump. These units use a VHF frequency to penetrate
through trees and crop foliage.
Use multiple pivots on the same well. -- Use multiple wells with the same pivot.
Basic irrigation controller MODEL
810-3 series
- Transmitter- one sensor input
- Receiver- one relay output
- Replaces buried underground control wire
- Start and stop pumps from pivot
- Battery backup for power outage at pivot
- Works with multiple pivots or wells
- Electric or engine driven well compatible
- System supervision for dependability
- Redundant signaling
Advanced Irrigation controller Model
810-3PLUS series
- Same basic features as above with more advance features
- Receiver- three relay outputs
- Transmitter- three sensor inputs
- Last pivot standing operation-will keep well on until last pivot is finished
- Different pivots can control up to three groups of well combinations
Transceiver (transmitter and receiver in one cabinet) Model 810-3RT series
This unit has a transmitter and receiver in one cabinet. Great for back and forth
switching of circuits, Pivot to Pivot applications. Use your imagination!
|
Model 810-3T plus
Transmitter |
Model 810R
Receiver in cabinet |
The HOT SHOT transmitter is located at the
pivot and is connected to the pivot's well kill circuit. |
||||||||||||||||||||||||||||||
|
Industral Power Powerful VHF signaling will penetrate through crops and trees. VHF signaling provides 25% greater range over hills than 900mhz signals |
The HOT SHOT controller will allow your panel to
request water-stop water. NO more driving to the pump to start water. |
HOT SHOT RECEIVERS can control electric or diesel
pumps. Includes 12vdc input terminals. |
||||||||||||||||||||||||||||||
Transmitters and receivers are mounted inside NEMA 4x weatherproof cabinets. Antennas are mounted on top of box. Easy hookup Also available are base mount long range fiberglass antennas for difficult terrain situations |
 Advanced lightning circuit protection. These
units have 8 surge protectors on the circuit board . MOV and ESD protectors 120vac- 8 volt and 5 volt protection Stops lightning
dead in it's tracks
Circuits protected against weather with FLEXON weather seal. |
|
||||||||||||||||||||||||||||||
Transceiver Transmitter and receiver in one cabinet.
model 810-3RT
|
||||||||||||||||||||||||||||||||
Pricing
Includes cabinet and antenna
Transmitter model 810-3T $ 429.00 m.s.r.p. (pivot)
Receiver model 810-3R $429.00 m.s.r.p. (pump-well)
Transmitter model 810-3T plus $449.00 m.s.r.p (pivot)
Reciver model 810-3R Plus $449.00 m.s.r.p. (pump-well)
Transceiver model 810-TRANS $489.00 m.s.r.p. (transmitter and receiver in one)
ACCESSORIES
HS-1 long range base fiberglass antenna 45.00
HS-2 ultra long range base fiberglass antenna 65.00
480 vac to 120 vac step-down transformer .05kv 28.00
480vac relays to activate 480v pump contactor (120vac coil) 15.00
Boost transformer for T&L electric pivot panel 24vac to 120vac (powers Hot Shot transmitter) 10.00
HOT SHOT SYSTEMS DEALER OPPORTUNITIES AVAILABLE WITH SPECIAL DEALER PRICING
